EUFAB 28289 Manual De Instrucciones página 3

CAR SEAT COVER SET
Assembly instructions:
Armrest of front seat:
The recess on the side of the car seat cover always needs to be attached where the airbag marking
is attached on the original car seat.
The seam on the car seat cover should always correspond exactly to the seam on the original car
seat. In the case of cars which do not have rear doors, you will need to create an opening for the
seat tilt lever by cutting the car seat cover at this point.
Headrest:
Remove the headrests and fit the car seat cover.
Car seat cover for front seat:
Align and attach below the seat with the rubber bands and the supplied hooks.
Armrest of back seat:
If necessary, remove the armrest of the back seat and align the height and width of the car seat
cover and attach using the rubber bands and the supplied hooks.
Back seat:
If necessary, remove the armrest of the back seat and place the car seat cover across the whole back
seat and then attach using the rubber bands and the supplied hooks. You do not need to dismantle
the back seat if it can be tilted forward.
Important:
After some time, the car seat covers should be stretched back into position in compliance with the
assembly instructions.
Safety information for car seat covers in cars with a side airbag:
The car seat cover is marked on the inside of the armrest and may not be confused with the lower
seat cover or another part of the car seat cover set.
The recess in the armrest part may only be positioned on the side where the side airbags are
positioned on the original seat. Steps must be taken to always ensure that the edge of the car seat
cover corresponds to the edge of the original car seat. After the car seat cover set has been cleaned
it should be refitted to the original car seats in compliance with these safety instructions.
Liability is excluded if these safety instructions are not observed or followed exactly.
EAL GmbH, D - 42115 Wuppertal
3