P L E A S E R E A D A N D F O L L O W A L L S A F E T Y T I P S
1. Before assembly, CAREFULLY use scissors or utility knife to cut and unwrap all parts. Make sure
you do not discard the hardware.
2. Make sure that you have all the parts listed. If you are missing any parts please email Customer
Service: www.twinstarhome.com or call 1-866-661-1218 in English, 1-866-374-9203 in French
or 1-866-661-1218 in Spanish. Please identify the parts you need and model number. Make sure
to include your name and address.
DO NOT MOVE MANTEL OR INSERT WHILE PLUGGED INTO POWER SUPPLY.
Some steps are more easily handled with two adults.
Attach the f ireplace insert to the completed wood mantel last. Install insert in from the back of the
fireplace so as not to scratch the hearth/base.
Use care in assembling your new f ireplace, take your time and use the hardware provided and a
quality Phillips head screwdriver.
NEVER OVER TIGHTEN BOLTS.
Do not sit on any part of the mantel.
1. Dust your fireplace regularly with a soft non-lint producing cloth or household dusting product.
2. You can clean your f ireplace with a gentle non-abrasive household cleaner. Make sure to dry your
fireplace immediately with a soft cloth or towel.
For a complete tight fit every bolt
should have a flat washer.
All panels are labeled Left and Right as viewed
from the front of unit.
1. Locate the Hearth/Base (A), Center Right Side
Panel (C) and Center Left Side Panel (B) and set
out on a scratch free surface.
2. Lay Hearth/Base (A) on it's back, face up.
3. Insert one Wood Dowel (N) into each of the
pre-drilled holes.
4. Push the Center Right Side Panel and Center Left
Side Panel snug to the Hearth/Base.
5. Make sure the Wood Dowels (N) are seated in
the pre-drilled holes.
6. Insert Bolts (L) and Washers (M) into the holes
in the mounting blocks.
HAND TIGHTEN ONLY.
E-2
GETTING STARTED
CAUTION:
HELPFUL HINTS
CARE & CLEANING
N
Hearth/Base
A
C
N
M
L
Center
Right
Side
Panel
N
B
N
Center
Left
Side
Panel