Ultradent Products PEAK LC BOND Manual Del Usuario

®
PEAK LC BOND
Light Cure Resin
Indications:
For use in most light-accessible bonding procedures.
Note: Peak LC Bond Resin is the adhesive resin used when utilizing a total etch procedure with the
®
following materials:
1. Dentin and Enamel, Section I
2. Metals, Section II
3. Composite Repair, Section III
Procedure(s):
Remove luer lock caps from syringes and attach appropriate tips:
Ultra-Etch: Blue Micro tip (some prefer the Inspiral
Peak LC Bond Resin: Inspiral
®
Section I. Dentin and Enamel
I. Prepare Tooth Surface: Prepared dentin and enamel surfaces to be bonded should be clean
and isolated. Surfaces should be caries free. For abrasion/abfraction Class V preparations,
roughen with a diamond bur. We recommend rubber dam where appropriate.
2. Etch: Apply Ultra-Etch onto preparation surfaces and leave for 15 seconds. Rinse dentin and
enamel thoroughly for 5 seconds with firm air/water spray. With brief air blasts, remove all visible
water. Leave dentin moist.
3. Bond: Immediately apply a uniform coat of Peak
an Inspiral Brush tip. Brush gently for 10 seconds. Using air syringe, gently thin adhesive to a
®
uniform glossy coat and continue drying for 10 seconds. Avoid pooling of adhesive. Surface will
look glossy. Light cure for 20 seconds using a standard light with an output less than 1000mW.
Light cure 10 seconds using a light with an output greater than 1000mW.
Description:
Peak LC Bond Resin is a syringe delivered single component resin
®
bonding system. Peak
either with the Peak
Etch, as treatment dictates. This light cure bonding agent is 7.5%
filled, radiopaque with an ethyl alcohol solvent carrier and will cure
with most curing lights including LEDs.
Brush tip
®
LC Bond Resin dental adhesive can be use
®
SE Primer or with a total etch, such as Ultra-
®
Brush tip)
®
LC Bond Resin onto etched tooth surface with
®