Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Honda Fit 2009-2013
KIT FEATURES
• ISO DDIN radio provision
• Painted to match factory dash
95-7877S – Silver
95-7877B – Matte Black
KIT COMPONENTS
• A) Radio housing • B) ISO DDIN brackets • C) ISO DDIN trim plate
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1729
Antenna Adapter: • 40-HD10 • 40-HD11 (with NAV)
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • 8mm Socket wrench
METRA. The World's best kits.
Installation instructions for part 95-7877
95-7877
C
™
metraonline.com
Table of Contents
Dash Disassembly ..................................................2
Kit Preparation ........................................................3
Kit Assembly
–
ISO DDIN radio provision ...................................... 3
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
Publicidad
Tabla de contenido
Manuales relacionados para Metra 95-7877
Resumen de contenidos para Metra 95-7877
- Página 1 Installation instructions for part 95-7877 Honda Fit 2009-2013 Table of Contents 95-7877 Dash Disassembly ..........2 Kit Preparation ............3 KIT FEATURES Kit Assembly • ISO DDIN radio provision – ISO DDIN radio provision ........3 • Painted to match factory dash 95-7877S –...
-
Página 2: Dash Disassembly
95-7877 Dash Disassembly 1. Unclip and remove the lower 5. Remove (2) Phillips screws center panel below radio. securing the air bag light to the (Figure A) back of the factory radio panel. (Figure E) 2. Remove (1) 8mm bolt facing up behind center panel. -
Página 3: Kit Preparation
4. Locate the factory wiring harness factory radio panel. and antenna connector in the Continue to kit assembly dash, and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Test the radio for proper operation. -
Página 4: Important
Installation instructions for part 95-7877 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. -
Página 5: Características Del Kit
Instrucciones de instalación para la pieza 95-7877 Honda Fit 2009-2013 Indice 95-7877 Desmontaje del tablero ..........2 Preparación del kit ..........3 CARACTERÍSTICAS DEL KIT Ensamble del kit • Provisión de radio ISO DDIN – Provisión de radio ISO DDIN ......... 3 •... -
Página 6: Desmontaje Del Tablero
95-7877 Desmontaje del tablero 1. Desenganche y quite el panel 4. Quite (2) tornillos Phillips que central inferior de debajo del radio. sujetan el interruptor de las luces (Figura A) intermitentes a la parte posterior del panel del radio de fábrica. -
Página 7: Preparación Del Kit
Metra Continúe con el ensamble del kit recomienda que use adaptadores adecuados de acoplamiento de Metra y/o de AXXESS. -
Página 8: Importante
Instrucciones de instalación para la pieza 95-7877 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...