Kicker QSS Serie Manual Del Propietário página 5

CROSSOVER CONFIGURATION
The KICKER QSS crossover can be confi gured as a conventional 2-way crossover by installing the
included INPUT jumper into the - MID + -TW + input terminals as shown in Fig. 2. In this confi guration,
the amplifi ed signal from your source unit or amplifi er should be wired to the + and - terminals indicated on
the INPUT jumper.
The QSS crossover can also be confi gured for bi-amp wiring by removing (or simply not installing)
the INPUT jumper. To use the bi-amp confi guration, you must connect two amplifi ed signals to each
crossover (you will need at least four amplifi er channels). Install one of the included tweeter output-
level jumpers (0 dB, +3 dB, or +6 dB) to adjust the tweeter output level. Installing jumpers with higher
numbers will result in more volume from the tweeter.
WIRING
We recommend using 16 gauge (or larger) wire. The QSS components are rated at 4 ohms and work
with any source unit or amplifi er designed to operate at a 4 ohm load. Make sure your source unit or
amplifi er is rated for 4 ohm operation.
Crossover in 2-way confi guration | One component set per channel
• At least two amplifi er channels are needed for stereo operation (only one channel is shown)
source unit / amplifi er
+
-
woofer
tweeter
crossover
OUT OUT
-MID+ - IN + -TW+
-OUT+
+
-
5