Mouting - Parrot CK3000 EVOLUTION Guía De Usuario

evolution3.qxp 10/02/2005
MOUNTING
If your Parrot EVOLUTION was installed by a professional, go directly to the next
section, the Connection Phase.
The Parrot EVOLUTION consists of an electronic control box, a microphone, a keypad
with "On" and "Off" buttons and two ISO car radio connection harnesses.
Electronic control box :
Do not install the control box close to the heater or the air-conditioning system. Protect
the control box from direct sunlight. Avoid enclosing the unit inside of metal components
this will adversely affect the quality of the Bluetooth® connection.
Microphone :
The microphone should be directed towards the driver and should preferably be installed
in between the visor and rear-view mirror.
Keypad :
We recommend you install the Keypad in an easily accessible place, preferably on a
clean, flat surface. Connect the Keypad to the connector provided on the mute cable.
Check that the red and green lights come on and go off according to the position of the
ignition key.
Connecting the mute cable and power cable :
The mute cable is equipped with black ISO connectors. The power cable is equipped
with grey ISO connectors.
Car radio with ISO sockets:
Disconnect the car radio speaker and power harnesses. Connect the mute cable and
power cable female connectors to the car radio. Connect the vehicle speaker and power
harnesses to the male connectors.
10:32 Page 5
Parrot EVOLUTION
7