Energy-Saving Tips; Freezer Installation; Electrical Connections - Haier HUM013EA Manual Del Usuario

English
Energy Saving Tips
• Do not place your freezer next to
a heating vent, a range, or in
direct sunlight.
• Do not open door more often than
necessary.
• Keep the door closed as much as
possible, especially, in hot and
humid weather.
• Cover foods to reduce moisture
build up inside the freezer.
• Store only foods that require
freezing.
• For proper air circulation, do not
overfill your freezer shelf.
Freezer
Installation
The freezer is designed for
freestanding installation only. It
should not be built-in. Allow a
minimum of 1 inch on each side and
above the top of the freezer to ease
installation and proper air
circulation. Be sure to install your
freezer in a place which is strong
enough to support the unit when
fully loaded.
4
Electrical
Connections
Important-for personal
safety, this appliance must be
properly grounded.
In the event of an electrical short
circuit, grounding reduces the risk of
electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
cord having a grounding wire with a
grounding plug. The plug must be
plugged into an outlet that is
properly installed and grounded.
Consult a qualified electrician or
service center if the grounding
instructions are not completely
understood. If doubt exists as to
whether the appliance is properly
grounded, have a qualified
electrician check the circuit to make
sure the outlet is properly grounded.
Do not, under any
circumstances, cut or remove
the third (ground) prong from
the power cord.
Use of Extension Cords
Avoid the use of an extension cords
due to potential safety hazards
under certain conditions.
English
4