Dyna-Glo DGPH301BL Manual Del Propietário página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
7. Assembly of the reflector (A) onto the
flame screen (B):
WARNING: Be sure to remove protective film
from the reflector (A) before assembly.
Screw the 3pcs reflector spacer (CC) on the
flame screen (B). Put 3pcs washer Φ6 (BB)
onto the top of the reflector spacer (CC).
Then put the reflector (A) onto the reflector
spacer (CC), securing them with 3pcs
washer Φ6 (BB) and 3 pcs M8 wing nut (AA).
Hardware Used
M8 Wing nut
AA
BB
Washer Φ6
Reflector
CC
spacer
8. Carefully install the glass tube(C) by lifting
up and inserting through the center hole in the
flame screen (B). Ensure the black silicone
ring(F) is attached to the lower edge of the
glass tube (C) as illustrated. Slide the glass
tube (C) through the hole of the lower plate
cover and onto the middle plate. Check and
ensure that the glass tube (C) is positioned
properly and is completely covering the center
hole of the middle plate.
WARNING! The black
silicone ring must be in place
prior to operating the heater.
7
AA
BB
A
CC
B
x 3
x 6
x 3
8
9
B
C
F
BLACK SILICONE
RING

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Dgph302ssDgph301bl-1

Tabla de contenido