General Inspection - TACKLIFE EGD15AC Manual Del Usuario

Operation
WARNING.
Always wear safety glasses when using this tool.
The engraver can be used to permanently mark metal, glass, plastic, wood,
ceramics and much more.
1. Before using the engraver you must ensure there is an engraving tip installed.
2. Connect the engraver plug to the power supply and while holding the engraver
firmly, push up on the on/off switch (1) with your thumb.
.
NOTE
To turn the tool on, press the small On/Off Switch (1) upwards to the (I) position.
To turn the tool off,push the on/off Switch (1) down to the (O) position.
3. Hold the engraver at an angle, like you would hold a pen. Do not press down
hard while engraving, use light pressure while guiding the point over the work
to be completed.
Adjusting the depth of engraving
1. The stroke adjustment dial (3) located on the side of the engraver controls
the stroke length and therefore the depth of engraving.
2. For a fine mark turn the stroke adjustment dial (3) anti-clockwise to position '1'.
3. For a deeper, thicker mark turn the stroke adjustment dial (3) clockwise to
position '5'
NOTE.
It is recommended that you practice on scrap material before you start.
Maintenance
WARNING.
Always ensure that the tool is switched off and the plug is removed from the
power point before making any adjustments or maintenance procedures.
1. Use a soft brush to remove any accumulated dust. Wear safety glasses to
protect your eyes whilst cleaning.
2. If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild
detergent can be used but never alcohol, petrol or other harsh cleaning agents.
3. Never use caustic agents to clean plastic parts.
CAUTION.
Water must never come into contact with the tool.

General inspection

Regularly check that all the fixing screws are tight. They may vibrate loose over
time.
- 05 -