Starting The Vacuum Blower; Before Commencing Work; Turning Off The Vacuum Blower - Fieldmann FZF 4020 E Manual Del Usuario

EN 12

Starting the vacuum blower

5. STARTING THE VACUUM BLOWER

Before commencing work

Before using this vacuum blower, connect it to a power source fitted with a residual current device and then
turn on this power tool. Check that the residual current device is working correctly.
Before starting this vacuum blower, check that the middle tube is secured in place correctly.
Warning! Before selecting the vacuum or blower function, check that the mode selection lever
(Fig 5, point 3) is in the normal position and that it is not blocked by materials from previous use.
Starting the vacuum blower
Using the mode selection lever (fig 5, point 3) located on the side of the vacuum blower unit, select one of the two
functions and then turn the power tool on using the On/Off trigger (fig. 5, point 1). You can adjust the power of
the power tool by moving the power adjustment dial (fig. 5, point 2) from position "1" to position "Max"

Turning off the vacuum blower

If you want to turn this vacuum blower off, simply release the On/Off trigger (fig. 5, point 1)
(fig. 5)
FZF 4020 E