brentwood JB-920B Instrucciones De Operación Y Seguridad página 5

4. When you have finished blending, press the pulse/off button. Make sure the blades have
come to a complete stop before attempting to remove the jar from the base. Turn the Jar
counter clockwise to remove from the base.
Blending Tips:
• Filler cap should only be removed to add ingredients. Do not remove the lid while the
blender is in use.
• Large foods should be chopped before placing into blender.
• If the mixture is very thick try adding some liquid and pulsing to a thinner consistency.
• While the appliance is OFF you can use a rubber spatula to scrape the sides of the jar.
Make sure you removed all utensils before continuing replace the Lid and blend.
• The Lid cap holds up to 30 ml of liquid and can be used to measure when adding ingredients.
• Please do not use your blender to make Bread Crumbs, Grinding Coffee Beans, and
Chopping Nuts, Whipping Cream, Beating Egg whites, Mixing Dough, Mashing Potatoes,
Grinding Meats or Extracting Juice.
• When using the Pulse function use short bursts. Allow the blades to stop completely
between pulses. Do not Pulse for more than 2 minutes.
• It is recommended to begin blending at a low speed and gradually increasing if necessary.
• If you will blend warm ingredients still steaming, remove the filler cap covering the opening
with a cloth to avoid splattering and blend only on the lowest speed. This allows any steam
to escape.
• Do not blend any of the following products in your blender:
− Large pieces of Frozen Food
− Raw Turnips, Sweet Potatoes, Potatoes
− Bones
− Hard Meats
− Boiling Liquids (allow to cool for 5 minutes)
• Do not store food in the Jar.
• Do not use blender if the Jar is chipped or cracked.
• It is recommended to rinse parts immediately after use to make cleaning easier.
Cleaning Your Blender:
WARNING: Always unplug the product and allow it to cool before cleaning or storing it. Allow
the Blades to come to a complete stop before removing Jar from base.
NOTICE: Never immerse the motor base, plug or cord in water or any other liquid.
• Make sure the Blender is not plugged in and remove the Blending Jar from the base.
• Only the Blending Jar, Lid, Filler Cap, and Blade Assembly can be washed under running
water. Do not use abrasive cleaners or pads.
• Handle blades with extreme caution. You may use a small nylon bristle brush to remove
food that has adhered to the Blade assembly.
• The motor base may be wiped with a soft damp cloth.
• Dry all parts thoroughly before storing or using again. Store in a cool, dry place.
5