Installation And Configuration - Bio Bronpi WIFI-1 Instrucciones De Instalación, Uso Y Mantenimiento

5.

INSTALLATION AND CONFIGURATION

The wifi module is suitable for operation in the home, through an active wifi network connected to the internet. The device is supplied with
two adhesive strips to fix it to a flat surface near the stove (stand, wall, etc.). It should not be installed in areas exposed to direct heat or heat
transmitted by radiation; the maximum temperature of use of the module is 50 ºC.
To install the module, the following steps must be followed:
1. - Connect the module to the stove with the appropriate interconnection cable supplied; the WIFI module must be connected to the
electrical current through the external power supply provided.
The manufacturer declares that
the type of radio equipment (Wifi-
1 kit) complies with the following
directives: RED 2014/53/EU; ROHS
2011/65/EU; RAEE
In the case of stoves without a serial port, the WIFI module must be connected directly to the electronic board at the CN13 connector using
the MODU II - MODU II interconnection cable.
When you first start using it, wait until LED A lights up with a permanent green light. If this does not happen, press the G "reset" button for 2
seconds.
The BRONPI HOME application must be downloaded to your computer, Smartphone or tablet. It can be downloaded directly from the PLAY
STORE or APPLE STORE servers, depending on your device.
The wifi module will create a network that serves only for the configuration of the module (it has no internet), identified as T009� followed by
the last 6 digits of the MAC code described on the label (see back) of the wifi module:
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Network
Connection 12V
The back-up power supply supplied in the kit complies with the
EN60950-1 directive and has the following characteristics:
- VELV: very low safety voltage;
- Protected against short circuits and over currents;
2012/19/EU. - Limited power supply (low power source LPS).
PE
CN9
Connection to
the stove via
serial cable
CN7
246F28842BD4
1891923
17 REMOTE CONTROL WIFI1 MODULE