Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
1.
Mounting instructions KRAZZMAXX III
1.1
Determining the mounting height
1.2
2.
2.4
3.
3.1
3.2
4.
5.
6.
7.
8.
9.
1. Mounting instructions KRAZZMAXX III
WARNING: Do NOT reach in behind the pro-
tective cover plate - there is a risk of serious
injury!
Procedure:
1. Determine the mounting height for the cow brush: see Chapter 1.1,
Page 1.
2. The mounting surface must be planar. The wall must be adequate to
support the weight of the cow brush (133 kg).
3. Using a harness, suspend the cow brush from a front-end loader or the
like: see Chapter 1.2, Page 2.
4. Mount the cow brush: see Chapter 1.3, Page 2.
5. Remove the transport protection: see Chapter 1.5, Page 2.
6. Install the switch box somewhere out of reach of the animals and not
subject to vibration or shocks. The switch box must not be mounted
on the cow brush (The vibration of the cow brush could damage the
electronics).
SUEVIA HAIGES GmbH • Max-Eyth-Str. 1 • 74366 Kirchheim am Neckar • Deutschland • Tel. +49 7143 971-0 • Fax +49 7143 971-80
7. If mounting on masonry, through bolts with large washers should be
used. For concrete walls, heavy-duty anchor bolts will normally be
adequate.
1
1
1.1 Determining the mounting height
2
2
2
2
3
3
3
3
3
3
3
3
3
Figure 1: Hole pattern for mounting
3
4
Height of first hole (Pos. 1, see Figure 1) = shoulder height of the animal +
4
25 cm. For example, with a shoulder height of approx. 140cm (see Figure
4
2), the height of the first hole would be approx. 165cm.
4
Note: Determine the average shoulder height of the animals and, if in
doubt, mount the device 2cm higher.
4
5
6
6
6
6
Figure 2: Example for determining the mounting height
EN 1/6
www.suevia.com • info@suevia.com • Stand: 30.05.2015
Pos. 1
340 mm
Publicidad
Capítulos
Tabla de contenido
