Shop-Vac SS11 Serie Manual Del Usuario página 4

27 28
A
A
30
Rear Wheel Dolly/Tool Holder And Front Caster Feet Assembly
(Not standard with all models)
You will find two casters (Figure 32), two large rear wheels (Figure 33), one axle (Figure 34),
rear dolly/
basket (Figure 35), two caster feet (Figure 36) and four screws with your wet/dry vacuum.
32 33
35
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down
so that the bottom is facing up.
2. Place axle upright on a hard surface and hammer on (1) cap nut. Place (1) wheel on axle
and slide down to cap nut (Figure 37). Be sure flat side of wheel hub is facing outward.
3. Slide axle through holes provided in dolly/basket (Figure 38).
4. Slide remaining wheel onto axle and hammer on second cap nut (Figure 39).
5. Take rear dolly assembly and place into slots (on rear of tank opposite drain) and secure
with screws provided (Figure 40).
6. With tank drain facing you, take caster foot marked with the letter A (Figure 41) and place
in slot on left side of tank also marked with the letter A and secure with screw provided
(Figure 42).
7. Take caster foot marked with the letter B (Figure 43) and place in slot on right side of tank
also marked with the letter B and secure with screw provided (Figure 44).
8. Insert casters into feet by placing stem of caster into holes provided. Apply pressure and
twisting motion until casters snap into place (Figure 45).
9. Return tank to upright position.
37 38
39 40
29
B
A
31
34
36
41
B
44
(Not standard with all models)
If your tool holder looks like the one pictured in Figure 46, follow these instructions.
1. With rear of unit facing you, take tool holder and position it with tabs facing rear of unit
(Figure 47).
2. Place "J" shaped tabs into the slots on cord wraps (Figure 48).
3. Press down until tabs snap into place.
4. Press down on center of tool holder until tab latches on bottom lid (Figure 49).
If your tool holder looks like the one pictured in Figure 50, follow these instructions.
1. With rear of unit facing you, take tool holder and slide over notches on rear of tank (Figure
51).
46
49
INSTALLING FOAM SLEEVE AND
REUSABLE DRY FILTER
(Not standard with all models)
WARNING
WALL OUTLET BEFORE REMOVING THE TANK COVER.
When using the reusable dry filter to pick up dust and dry material, you must install foam
sleeve and reusable dry filter to ensure proper filtration. If the vacuum has been used to pick
up liquids, the foam sleeve must be cleaned and dried before installing for dry pick up. With
tank cover in an upside down position, slide foam sleeve down over lid cage pulling until foam
sleeve completely covers lid cage
(Figures 52, 53). Center the reusable dry filter on lid cage (Figure 54), slide mounting
ring down over filter until ring is positioned against the ribs of the lid cage (Figure 55).
The reusable dry filter should always be in position over the foam sleeve for dry pick up.
To remove the filter for cleaning, remove mounting ring and filter from lid cage (Figure
56). To clean the reusable dry filter, shake off excess dirt and dust or (depending on the
condition of the filter) rinse with water. Allow the filter to dry completely and re-install.
DO NOT MACHINE WASH OR DRY.
52
42 43
A
45
TOOL HOLDER
47 48
50 51
DRY PICK UP
– ALWAYS DISCONNECT THE PLUG FROM THE
53 54