DATEC LG2215TC Manual De Instrucciones página 6

Electronic Control Unit LRX 2215 TC
Electronic control unit for the automation of rolling shutters and sun blinds, with option-
al Wind sensor connection and keypad/radio control operation, for individual and cen-
tralised control.
- Mod. LG 2215TC :
- Mod. LRS 2215TC :
- Mod. LRS 2215TC SET:
- Mod. LRH 2215TC :
T
ECHNICAL DATA
- Power supply:
- Motor output:
- Operating temperature:
- Radio receiver:
- Compatible radio controls:
- N° of codes which may be stored:
- N° of Wireless Wind Sensors which may be stored:
- Packaging dimensions:
- Container:
Without radio receiver
433,92 MHz
"Narrow Band" 433.92 MHz
"Narrow Band" 868.3 MHz
230 V~ 50/60 Hz 600 W max.
230 V~ 500 W Max.
-10 ÷ 55°C
see model
12-18 Bit or Rolling Code
Max. 6
Max. 3
110 x 121 x 47 mm.
ABS UL94V-0 ( IP54 )
C CN1 T
ONNECTION OF ERMINAL BOARD
1: 230 V line input (Phase).
2: 230 V line input (Neutral).
3: Upward movement motor output.
4: Shared motor output.
5: Downward movement motor output.
C CN2 T
ONNECTION OF ERMINAL BOARD
1: Wind sensor input "W".
2: Local Input T1 Cyclical button (NO).
3: Shared GND Signal input.
4: Local Input T2 Cyclical button (NO)..
5: T3 general upward movement button input (NA).
6: Shared GND Signal input.
7: T4 general downward movement button input (NA).
8: Earth antenna input.
9: Antenna hot pole input.
I O
NITIAL PERATING CONDITION
The equipment can function via Local T1 (Cyclical), T2 (Cycli-cal) control buttons,
General T3 (Up), T4 (Down) buttons and coupled with one or more radio-controls. There
is no radio-control code stored in the factory setting.
OPERATIONAL DATA:
Local Cyclical T1 and T2 control buttons functioning:
By connecting local control buttons to the low voltage inputs T1 or T2 (normally open)
to activate the frame, the following func-tioning is obtained:
the first impulse controls upward movement until motor time expires. The second
impulse controls downward movement; if an impulse arrives before expiry of the motor
time, the control unit stops the frame. Another impulse re-starts movement in the oppo-
site direction.
T3 – T4 General command buttons operation:
The following type of operation is obtained by connecting the general command but-
tons (normally open) for movement activation to the low voltage inputs T3 – T4:
T3 controls upward movement until the motor running time has elapsed and T4 con-
trols downward movement. If a command is sent in the same direction before the motor
running time has elapsed, the control unit will ignore the command; if a command is
sent in the opposite direction before the motor running time has elapsed, the control
unit will invert the direction of the motor.
O M
PERATION USING DIFFERENT ODELS OF
Different models of radio control may be programmed: by storing one code (1 button)
a cyclic step by step operation (Up - Stop - Down) is achieved, and by storing two dif-
ferent codes (2 buttons) separate commands are created, one for upward movement
and one for downward movement. Storing a BeFree series radio control (3 buttons)
produces three separate commands: the first button is used for upward movement, the
- 6 -
R C
ADIO ONTROL
GB