Cleaning, Care And Maintenance - Bausch Easy pedipeel 0328 Instrucciones Para El Uso

gb
2. Wash and clean your skin and dry it.
Attention: Never use the device on turn, ripped or bleeding skin.
3. Be sure that the turning grinding head attachment (B) is inserted correctly and engaged.
4. Remove the protective cover (A) from the attachment (B).
5. Press the safety lock (D) and simultaneously push the on/off switch (E) forward to turn the power on.
6. Circle the EasyPedipeel over the affected areas for 2-3 seconds. Do not press too firmly; otherwise
you might dislike the feeling and the device will stop! Repeat this step until you have reached the
softness you want to achieve.
Attention: Never circle over the same area longer than 2-3 seconds! Stop the process if your skin
gets too thin or hot!
7. Turn off the device after finishing your pedicure.
8. Clean your skin from all remaining skin particles and use enriched foot lotion for soft and healthy
feet.
EXCHANGE OF THE ATTACHMENTS
J
The turning grinding heads are interchangeable and can be exchanged on demand.
1. The device has to be turned off.
2. Push the release button (C) on the side of the EasyPedipeel and remove the grinding head (B) easily.
3. Attach another grinding head to the device. Make sure that the attachment is fully engaged. This is
just possible if installed properly!
TIP: The small gear-wheel on the bottom side of the attachment has to point into the same direction
as the gear-wheel of the top side of the device! If installed correctly, you will hear a "click" sound.
4. Place the protective cover (A) over the attachment.
Tip: Do not turn on the device if there is no attachment attached to it!

CLEANING, CARE AND MAINTENANCE

J
Tip: To ensure a constant performance of the device, clean it after every usage thoroughly. You can rinse
the attachment under running water without any concerns. Do not immerse the device into water! Do not
clean it with chemicals! The device is maintenance-free, be careful with it!
1. The device has to be turned-off during cleaning.
2. Push the release button (C) on the side of the EasyPedipeel and remove the grinding head (B) easily.
3. Remove all remaining skin particles with the cleaning brush (I). You are able to clean dust and skin
particles from handle and attachment with it.
4. Rinse the head piece of the device with water. While doing so turn the roll. You can also use soap for
cleaning the grinding head attachment. You may disinfect the attachment by using disinfectant spray
on it.
5. Dry all the parts with a towel.
6. Attach the grinding head to the device. Make sure that the attachment is fully engaged. This is just
possible if installed properly!
Tip: The small gear-wheel on the bottom side of the attachment has to point into the same direction
as the gear-wheel of the top side of the device! If installed correctly, you will hear a "click" sound.
7. Place the protective cover (A) over the attachment.
Tip: Do not turn on the device if there is no attachment attached to it.
REPAIR INSTRUCTIONS
J
Attention! Electric devices are only fixed by qualified personnel. Improperly repairing can result in
severe consequential damage.
DISPOSAL
J
This product as well as any other electronic and electrical appliances, which have reached the end
of their lifetime, must be collected and disposed of separately from household waste material.
gb