VEFXi 3D-Bee Diamond Manual Del Usuario página 4

Connect the 3D-Bee power
cable from the DC jack to
a 100-240V 50/60Hz AC
power outlet. Power on all
devices in this order: your
3D-Bee, your 3D TV and
then your other devices.
Use the SOURCE button on
the remote to switch inputs
and use the 3D button to
turn on the 3D conversion.
Find more remote instruc-
tions below.
POWER-ON SCREEN: Press
SOURCE to select the
desired input for display on
the screen. To accept the
license and exit the power-
on screen press either the
<PREV or NEXT> button.
Press the NEXT> button to
configure the 3D-Bee for
side-by-side output, the
format used by most 3D
TVs. Press the <PREV but-
ton to configure the 3D-Bee for frame-sequential mode, a format used by common
3D projectors. If you want to change your 3D output format, power off the 3D-Bee
and power it back on and then select the desired mode at the power-on screen.
3D-Bee Remote Control Buttons
SOURCE: This button cycles through the four input sources attached to the 3D-Bee.
Both the LEDs on the 3D-Bee's face and a number on the on-screen display (OSD) will
indicate which input you have selected.
3D: This button activates the 3D preset mode and allows you to select one of the six
3D presets to best match the content and your taste. The default 3D preset mode
after power up is Movie+. Use the <PREV and NEXT> buttons to move through the
3D preset modes. The name of the selected preset is shown on the screen. The six
presets are: Movie, Sports, Gaming, Movie+, Sports+ and Pop-out.
The Movie preset positions everything behind the screen and has a depth setting of
3 out of 11. This setting is very easy on the eyes and can be watched comfortably for
4