Locking / Unlocking The Microphone; Mute Function - Monacor JTS MH-8800G/5 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.3 Locking / Unlocking the microphone

With the microphone locked, it is not possible
a to switch off the microphone; if the POWER
switch (9) is set to OFF with the microphone
locked, the display will show
b to call up the adjusting modes for group /
channel and sensitivity
5.3.1 Activating the locking function
1) Keep the key SET (6) pressed for 2 s until the
display briefly indicates
press the key SET three times again so that
the indication
(locking deactivated)
2) Press the key
display
3) To save the adjustment, press the key SET The
display will briefly indicate
ing mode will be exited, and the microphone
will go to normal operation
5.3.2 Deactivating the locking function
1) The POWER switch (9) must be set to POWER
2) Keep the key SET (6) pressed for 3 s until
flashes on the display
3) Press the key
(4):
display
4) To save the adjustment, press the key SET The
display will briefly indicate
ing mode will be exited, and the microphone
will go to normal operation

5.4 Mute function

The mute function is designed for short interrup-
tion of the signal transmission ("throat clearing
mode" or "enquiry mode") with subsequent im-
mediate readiness for op eration without delay
1) Set the MUTE switch (11) at the lower end
of the microphone to the position MUTE If
required, slide the safety cap (10) upwards
beforehand When the mute function is
switched on, MUTE will be shown on the
display of the receiver
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
Then briefly
flashes on the display
(5):
flashes on the
, the adjust-
flashes on the
, the adjust-
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
2) To continue signal transmission, set the MUTE
switch to the position OFF
Note: In the switch position MUTE, there will be no
speech transmission; however, the microphone will
still be in the transmission mode and consume power
Therefore, always switch off the microphone with the
POWER switch (9) [position OFF] for longer interrup-
tions
6
Specifications
Type of unit:
Directivity:
Radio frequency
range:
Audio frequency range: 50 – 16 000 Hz
Frequency stability:
Transmitting power:
Ambient temperature: 0 – 40 °C
Power supply:
Dimensions:
Weight:
Subject to technical modification
dynamic hand-held
microphone with PLL
multifrequency trans-
mitter
hypercardioid
518 – 542 MHz, di-
vided into 64 channels
(
table fig 4)
 
±0 005 %
50 mW (EIRP)
two 1 5 V batteries
of size AA (R6)
⌀ 53 mm × 240 mm
370 g
11

Publicidad

Tabla de contenido
loading

Tabla de contenido