Publicidad
INSTALLATION AND OPERATION
1. Consider the following to determine the best location for your solar
LED EggLites:
•
The lights can be used dry or submerged in your water feature.
The solar panel should not be submerged, but can withstand
rainy, outdoor environments.
•
Each light comes with a 16-inch pliable cord that can be formed
to stand on its own or coiled around foliage and fountain heads
in the landscape.
•
Choose a location for the solar panel that maximizes its
exposure to the sun. Locate the solar panel so that its surface
is mostly perpendicular to the sun's rays throughout the day.
•
The solar panel can be secured using one of two methods.
1) Ground Stake: Use the attached ground stake to secure the
panel into the ground of the landscape (Figure 6). To adjust the
orientation of the panel to the sun, loosen the stake screw,
pivot the panel to the desired orientation, then tighten the
screw. 2) Frame Mounting: The solar panel frame has slots
that accommodate a variety of mounting methods. Use #6 size
Figure 4 • Figure 4 • Figura 4
Photocell
Photocellule
Photocell
Fotocélula
Test button (Use only in TEST
mode)
Bouton TEST (utilisez
TEST button
uniquement en mode TEST)
(Use only in TEST
Botón "TEST" (Prueba) (sólo
mode)
se utiliza en el modo "TEST"
[Prueba])
Solar panel
Panneau solaire
Solar
Panel solar
panel
Figure 5 • Figure 5 • Figura 5
2
RUN
MARChE
FUNCIONAMIENTO
RUN
MODE switch
MODE
Commutateur
de MODE
switch
Cambiar "MODE" (Modo)
TEST
TEST
TEST
(Prueba)
Solar panel
Solar
Panneau solaire
panel
Panel solar
wood screws (not included) to secure the panel to a fixed board
or post, or use wire (not included) to loop through the slots and
secure the panel to a fence or similar item.
•
An optional extension cord (5 or 10 foot) can be purchased to
provide greater distance between the EggLites and the three-
way connector. See list of accessories (sold separately).
2. Install the pre-assembled lights and solar panel.
3. Check to see that all LED EggLites illuminate when the ambient light
turns dark.
MAINTENANCE
1. BATTERY: Although your kit's battery has a long life, it may eventually
need to be replaced. Please follow the instructions below:
a. Loosen the stake screw at the stake pivot point and rotate the
stake to allow access to the battery cover (Figure 6).
b. Remove the 2 battery screws from the cover.
c. Remove the battery cover.
d. Remove the battery and disconnect the cable.
e. Connect and install the new battery. Use an authorized replacement
battery only (see Replacement Parts table).
f. Replace the battery cover and secure it with the 2 cover screws.
g. Rotate the stake back to its original position and tighten the stake
screw.
2. PhOTOCELL: For proper operation of the automatic on/off feature,
periodically clean the photocell window using a clean, damp cloth
(Figure 5).
Figure 6 • Figure 6 • Figura 6
Mounting slots
Fentes de montage
Ranuras de montaje
Stake screw
Vis pour piquet
Tornillo de la estaca
Ground stake
Piquet de terre
Estaca al suelo
Battery cover
Couvercle de la pile
Cubierta de la batería
Cover screw (1 of 2)
Vis du couvercle (1 de 2)
Tornillo de la cubierta (1 de 2)
Mounting slots
Rainures de montage
Ranuras de montaje
Publicidad
