Configure The Bar Code Slot Reader; Install An Sd Card - Honeywell CV31 Manual Del Usuario

Configure the Bar Code Slot Reader

Install an SD Card

CV31 Data Collection Computer User Manual
If you installed the bar code slot reader (Model AR3) accessory, you
need to enable and configure it before you can use it.
1 Tap Start > Settings > Control Panel > Intermec Settings.
2 Tap Data Collection > Tethered Scanner (COM3) > Scanner
Settings.
3 Tap Scanner Model.
4 From the list, select ID Tech Slot Scanner.
5 Select Enable Scanner Port.
6 Tap OK.
7 Tap Data Collection > Tethered Scanner (COM3) >
Symbologies.
8 Only enable the symbologies that you plan to read.
Use an SD card to increase file storage or install software. The
computer resets when you install or remove an SD card.
1 Press and hold the Power button for more than 8 seconds to turn
off the computer.
2 Disconnect the power cord from the computer.
3 Use a Phillips screwdriver to remove the six screws that secure the
radome cover.
Chapter 1 — About the Computer Features
13