Intended Use; Product Description; Installation And Maintenance - Quick QCC-LCS TP Manual De Uso

CHARACTERISTICS / INSTALLATION
EN

INTENDED USE

• The QCC-LCS TP interface is intended to be used in nautical applications to control and adjust the brightness of LED
RGBW light sources.
• The product is used to control the RGBW system.
• For fire-prevention reasons, install the QCC-LCS TP interface in a ventilated, controlled-temperature environment,
protected from dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Any other use should be considered improper and unpredictable.
F
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT. IN CASE OF
DOUBT, CONTACT YOUR DEALER OR QUICK
THE PACKAGE CONAINS: QCC-LCS TP - conditions of warranty - the manual of installation and use.
TECHNICAL ELEMENTS AND DEFINITIONS
• touch pad: In this specific manual this is a panel in which you just have to tap a key with your finger to activate the
associated function.
• RGBW system: In this specific manual this is an electric lighting system that consists of an assembly of RGBW LED light
sources and electronic devices that control and check such lights..
• DMX512: Communication protocol that transmits the instructions for managing the RGBW system.
• light zone: In this specific manual this is a set of RGBW light sources so connected that they can receive the
instructions to switch on/off and to adjust intensity and colour.

PRODUCT DESCRIPTION

The QCC-LCS TP interface is a control device with a touch pad to control an RGBW system. It can control up to four light
zones.
ZONE SHIFT KEYS

INSTALLATION AND MAINTENANCE

• Always disconnect the supply voltage during installation and maintenance operations.
• Drill a hole on the installations panel. The inner diameter of the hole should be the same as that of the assembly frame.
Fasten the assembly frame using two self-tapping screws. Snap-fit the QCC-LCS TP interface into the assembly frame.
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the product.
• Turn on the power, MAKE SURE THE POLARITY IS RIGHT.
MODE KEY
RGBW KEYS
(see explanatory drawing on page 16)
CUSTOMER SERVICE.
®
8
QCC-DRV CH4 - REV001A
COLOUR SELECTION KEY
BRIGHTNESS/SPEED KEY
ON/OFF KEY
QUICK SPA