REFRIGERATOR INSTALLATION
Using 10mm or 13 / 32 inch socket wrench, remove the
three bolts and lift off the top hinge. Set parts aside.
Top Hinge
Slightly lift up the refrigerator door and remove it.
Middle Hinge Bracket
Turn the freezer door upside down on a non-scratch
surface.
Loosen the screw to remove the Door Closer/Stop and
Hinge Pin Insert.
Door Closer / Stop
Move the Hinge Pin Insert Bracket to the other side of the
door, keeping the same orientation, and move the Hinge
Pin Insert into the hole on the left side of the bracket.
Reverse the Door Closer/Stop by flipping it over. Place it
on top of the Hinge Pin Insert Bracket, and tighten both
down with the screw.
Hinge Pin
Hinge Pin Insert
Hinge Pin
Insert Bracket
Pry off the cover on the top left side of the refrigerator to
uncover the screw holes.
Set the freezer door and top hinge parts to the side and
remove the refrigerator door.
REVERSING THE REFRIGERATOR DOOR
Remove the Hinge Hole Plug and the two screws
located in the upper part of refrigerator handle with a
screwdriver.
Hinge Hole
Plug
Handle
Loosen the upper set screw with a 3 / 32 " hex wrench and
remove the handle. The refrigerator handle is going to be
the freezer handle when reversing doors.
NOTE: Grasp the handle tightly so that it does not fall
when the screws are removed.
Screw
Wrench
Handle
14
Cover
(on top of
refrigerator)
Screws