Reverse The Door Swing; Tools Needed - Whirlpool EL02CCXPB00 Manual De Uso Y Cuidado

Reverse the Door Swing

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
TOOLS NEEDED: ⁵⁄₁₆" hex-head socket wrench, flat-blade
screwdriver, flat 2" (5 cm) putty knife.
IMPORTANT: Before you begin, turn the refrigerator control to 0.
Unplug refrigerator or disconnect power. Remove food and all
loose items from the inside of the refrigerator.
Remove the Door
1. Unplug refrigerator or disconnect power.
2. Use the putty knife to pry up and remove the hinge cover.
A. Hinge cover
3. Remove the ⁵⁄₁₆" screws from the top hinge. Keep these
screws for later use.
⁵⁄₁₆
A.
B. Top hinge
4. Remove the top hinge. Keep all parts together.
5. Use the putty knife to remove the door hinge hole plug and
move it to the opposite side of the door as shown.
A
A. Door hinge hole plug
4
A
A
B
" screws
6. Lift the door up and off of the bottom hinge. Place on a soft or
padded surface to avoid scratching.
7. Use the putty knife to remove the hinge hole plug and move it
to the opposite side of the refrigerator as shown.
A
A. Hinge hole plug
Reverse the Hinges
1. Lay the refrigerator on its side on the floor. Make sure the
surface is not abrasive to avoid scratching.
IMPORTANT: Never lay the refrigerator on its back or top.
Doing so could cause damage to the compressor.
2. Remove the ⁵⁄₁₆" screws from the bottom hinge. Keep these
screws for later use.
A
B
C
D
A. Bottom hinge pin
B. Leveling leg
C. Bottom hinge
⁵⁄₁₆
D.
3. Remove the bottom hinge. Keep all parts together.
4. Unscrew the leveling leg from the opposite side of the bottom
of the refrigerator.
5. Insert the leveling leg in the middle screw hole of the "old"
location of the bottom hinge. You may need to use a
screwdriver to clear out the hole.
A. Leveling leg
screws
"
A