Publicidad
Idiomas disponibles
Idiomas disponibles
Tips for Better Results
lf the above does not happen, check the points listed below:
1. Check if the Mode Selector Switch is on.
2. Check that the batteries are inserted correctly according to
t h e p o l a r i t y d i a g r a m .
3. lf the batteries are correctly inserted, replace them with
new ones.
*
D o n o t t o u c h t h e F i l m A d v a n c e C o u p l e r ( 3 ) w h i l e i t i s i n
a c t i o n a s i t m a y c a u s e i n j u r y .
P R E P A R I N G T O S H O O T
1. Before attaching the Winder to the camera, wipe the
W i n d e r C o n t a c t s ( 5 ) a n d t h e P o s i t i o n i n g P i n ( 7 ) e t c . w i t h a
c l e a n d r y c l o t h .
2. Insert the Attachment Screw/Knob (6) of the Winder into
t h e c a m e r a ' s T r i p o d S o c k e t a n d t u r n i t . W h e n i t h a s
e n g a g e d , c h e c k t h a t t h e P o s i t i o n i n g P i n s o n t h e W i n d e r f i t
properly into the Positioning Pin sockets on the camera,
then tighten the Attachment Knob to lock into position.
( F i g . 4 )
3. lnsert the film as shown in the camera instruction booklet.
4. Push the Film Advance Lever in until it covers the red dot
c o m p l e t e l y . ( F i g . S )
Tips for Better Resutts
*
lf the Film Advance Lever is not correctly positioned. the
W i n d e r w i l l n o t o p e r a t e .
S H O O T I N G
1 . S e t t h e M o d e S e l e c t o r S w i t c h ( 1 O ) t o
' S ' ( S i n g l e
F r a m e ) o r
' C ' ( c o n t i n u o u s )
a s d e s i r e d . ( F i g . 6 )
- 3 -
Publicidad
