ratiotec CONNECT Manual De Instrucciones página 8

EN
Commissioning
The pagers are still in sleep mode when they are first
installed. To activate the pagers, they have to be supplied
with power. Connect the provided power cable with the
connector on the charging station and a power source.
Stack the pagers one at a time on the charging station.
Please note, that the silver contact screws must be on top of
Integrated magnets in the pagers and the charging station
ensure a stable and secure hold. Before using the pager for
the first time, charge it for at least 8 hours.
8
each other, so that a permanent
connection is established and
all pagers can be charged. For
the correct placement, you can
use the LED or the bulge in the
silicone sleeve on the front of
the pager as an orientation. The
pagers should be placed on the
station so that the LEDs or the
bulges in the cover are all on the
front side of the stack. This only
applies for the pagers. The power
supply is located on the back of
the pager base. See image.