Electrical Connection - Norlake KOLD LOCKER Manual De Instalación

W -I M
ALK N AINTENANCE

ELECTRICAL CONNECTION

Referring to the wiring diagram in the "Electrical Connections" section of this manual, connect the heater wire leads
as shown. If short lengths of the lead wires were left as indicators, connect the replacement heater leads to those
points of connection and discard the short indicator lengths.
NOTE: If one of the heater leads connects to another wire through a wire connector, obtain a properly sized, twist-
on wire connector for this purpose.
Replace the pilot light and switch in the switch box and attach the switch cover to complete the job. Energize the
walk-in cooler to resume operation.
POSITIONING THE THERMOMETER SENSING BULB
For convenient monitoring of
the temperature in the storage
compartment of this walk-in, a digital
thermometer is located directly
above the light switch.
For optimum accuracy, the sensing
bulb must be exposed to the air
that is being monitored. Make
certain that the sensing bulb is not
positioned near the interior light or
any other heat producing device, nor
should it be located where stored
products shield the sensing bulb
from the circulating air pattern within
the walk-in. The long sensing lead
is more than adequate to provide an ideal sensing bulb placement
on the inside surface of the door section or an adjacent wall or
corner panel. When the location is finalized, an adhesive backed,
plastic clip is used to secure the sensing bulb to that surface.
PANEL CLEANING AND MAINTENANCE RECOMMENDATIONS
During the course of uncrating, handling and installation, the panel surfaces of your walk-in cooler or freezer may
have become stained or dirty. Cleaning all metal type surfaces, door trim and gaskets can be performed with a mild
detergent and hot water. It is important that you remove all excess soap and dry the surfaces thoroughly. Never,
under any circumstances, use an abrasive or alkaline solution.
Occasionally it may become necessary to clean the interior surface for sanitary purposes. A mild solution of baking
soda and warm water will tend to impart a clean, sweet smell to the interior should odors occur from spillage or
container breakage. Never leave standing water inside the walk-in cooler or freezer.
26
© 2008 Nor-Lake 4/08 PN 121428