Advance mobility baby jogger Freedom Instrucciones De Montaje página 11

FRAME
1 Unpack the pushchair frame from the
box and set the wheels aside. If not
assembled, attach L shaped tubes to
frame as shown.
2 Unfold frame.
3 FOOTPLATE
• Rotate lower end tubes of pushchair
frame.
• Insert footplate onto the pushchair
frame.
• Secure footplate onto pushchair
frame using the enclosed screws. A
phillips screwdriver will be needed.
Note: Use tapered screws to secure
the center of the footplate.
4 Attach foot end of seat pad to front of
footplate with hook and loop patches.
Wrap straps around bottom of
footplate, insert strap through D-ring
and attach hook and loop patches.
5 Check that basket is attached to foot
frame with snap straps as shown.
6 Swing bottom frame tubes toward
footplate. Insert bottom of footplate
into front tube connectors. Push up to
secure snap locks on both tubes.
7 Place the pushchair in the upright
position. Swing side braces down to
mounting brackets. While pushing
latch button, slide side brace over
mounting bracket, release when pin
is aligned with hole in bracket. Secure
side brace clamp.
Repeat on both sides.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
8 Installation
• To install front wheel, lay pushchair
back so handle is resting on floor.
Open the calipers by flipping the
caliper lever toward the rear.
• Insert the front wheel assembly into
the front frame tubes until pin holes
are aligned.
• Insert wheel pin on each side.
• Close caliper by flipping the caliper
lever toward the front.
Removal
• Reverse installation steps.
FRONT SWIVEL WHEELS
9 Installation
• To install front swivel wheels, lay
pushchair back so handle is resting
on floor.
• Insert the front wheel assembly into
the front frame tubes until pin holes
are aligned.
• Insert wheel pin on each side.
Removal
• Reverse installation steps.
SWIVEL FEATURE
10 Push the swivel lock button up to lock
the front wheel to a fixed position.
11 Press the swivel lock button down
to allow the front wheel assembly to
swivel.
WARNING: When loading and
unloading passenger, lock the front
wheels in a fixed position. Although
the front wheel of your pushchair
locks, it is not intended for jogging or
exercise purposes.
REAR WHEELS
12 Installation
• Align the rear wheel axle with the
wheel mount on the pushchair
frame and insert it into the wheel
mount until it locks into place. You
will hear a click.
• Gently pull on the rear wheel to
make sure it is properly attached.
13 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
HAND BRAKE
Hand Brake with Parking Button
14 To use the parking button feature,
squeeze the brake handle (12) and
push the park brake button (11).
WARNING: Lock the brakes before
loading and unloading your passenger
and whenever the pushchair is not
moving.
11
EN