Publicidad
Idiomas disponibles
Idiomas disponibles
Technical Specifications:
Weight
Voltage / Frequency
Power
Insulation type
Glue temperature, t° regulation type
Glue sticks specifications
The manufacturer reserves the right to change specifications without notice.
Safety Instructions:
Read carefully before using the Glue Gun – Hot Melt applicator
-
HOT SURFACES: The glue and the nozzle of the tool can reach temperature up to 200°C (400°F).
Avoid all skin contact. If burnt, plunge the burn under cold water. Never attempt to remove large lump
of glue from burnt skin without medical assistance.
-
Do not use the tool in damp or wet conditions or expose it to water projections.
-
If the power supply cable is damaged, unplug the tool by pulling the plug out of the wall socket. Never
pull the cord to unplug the tool.
-
Never put object in the tool other than recommended Glue stick specific diameter.
-
Never take a Glue stick out of the tool once it has been put into the tool. Molten glue could create
irreparable damages to the tool.
-
Children should only use the tool under supervision of an adult.
-
Always unplug the tool prior to proceed to maintenance or cleaning.
-
Always make sure that the tool is connected to a 220-240V / 50Hz wall socket with ground
connection. If need be, an extended power cord in perfect condition can be used.
-
When unplugged, always make sure that the tool is at room temperature prior to store it.
Use of the tool:
-
Start-up : Plug the tool into a 220 - 240V / 50Hz wall socket with ground connection. Working
temperature is obtained after 3 to 4 minutes.
-
Temperature selection :
According to the Glue specifications, use the external switch located near the power
cord entrance into the tool, to select the appropriated temperature:
-
Introduce glue sticks at the back end of the tool.
-
Place the nozzle of the tool against the surface and press gently on the trigger to extrude glue. Place
the second element in contact with the glue, if need be adjust it and press parts together during
average of 10 seconds.
-
To change Glue stick type, never remove glue stick in use. Cut exceeding part of glue stick in the tool
and introduce new glue stick into back end of the tool. Press the trigger several times to purge old
glue from the tool.
-
If the tool will not be used for a period exceeding 30 minutes, unplug it.
-
Once the job done, unplug the tool.
Recommendations:
If the power supply cord is damaged, it must be replaced by the manufacturer, manufacturer's service
-
representative or authorised trained technician.
-
Discard of the tool. The owner of the tool must bring the tool to a recognised dedicated recycling
station / green point.
GB
- lower temperature: switch in back position (-).
- higher temperature: switch in front position (+).
0,500 kg
220 - 240 V / 50Hz with Ground connection
380 W at Start-up
280 W in use
Class I
180°C (360°F) and 205°C (400°F), Regulated by 2
thermostats. Temperature selection done by
external switch.
Ø 12 mm
- 6 -
Publicidad
