Vibration Level; Battery Level - Rebel RB-1031 Manual Del Usuario

Vibration level

The vibration emission level stated in this instruction manual has been measured in
accordance with a standardized test given in EN 60745; it may be used to compare one
power tool with another and as a preliminary assessment of exposure to vibration when
using the power tool for the applications mentioned.
• Using the power tool for different applications, or with different or poorly maintained
accessories, may significantly increase the exposure level.
• The times when the power tool is switched off or when it is running but not actually
doing the job, may significantly reduce the exposure level. Identify additional safety
measures to protect the operator from the effects of vibration such as: maintain the
power tool and the accessories, keep the hands warm, organization of work patterns.
OPERATION
Note: The battery is partially charged. To ensure proper operation of the power tool,
the battery must be fully charged before first use.

Battery level

To check the battery level press the button at the back of the battery:
• When the battery is fully charged, all three LEDs are on.
• When the battery is half empty, two LEDs are on.
• When the battery is empty, only one LED is on. Charge the battery immediately.
Charging
• Place the AC charger on a flat and stable surface within about 1 meter from the power
supply socket.
• Remove the battery from the power tool. Press and hold the battery release button (4)
and slide out the battery at the same time.
• Slide the battery to the AC charger maximally so that it locks in place.
• Connect the AC charger to the power supply socket.
• When the battery is fully charged, slide it out from the AC charger and slide it in the
power tool so that it locks in place.
Charging indicators
The AC charger has charging indication lights which indicate the status of the charging process:
LED
Red
Green
Battery charging in progress
Battery charging finished, battery fully charged
43
Status
EN