Parts Included - EDM 50141 Manual De Instrucciones

INSTRUCCIONES IMPORTANTES DE SEGURIDAD
50141
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
GENERAL INFORMATION
Make sure to use the studs in your wall before mounting the wall plate. Do not mount this
product into the drywall. Do not mount this product on drywall, unless it is ensured that it is
capable of supporting the weight.
- Distance min / max. the wall: 7,2-41cm
- Arm swivel angle, left and right: 120º
- Tilt angle: +5º / +15 °

PARTS INCLUDED

A.- (4x) M8x50 fixing bolt
B.- (4x) M10x50 plug
C.- (4x) M5x20 fixing screw
D.- (4x) M6x20 fixing screw
E.- (4x) M8x25 fixing screw
F. - (2x) M4x40 fixing screw
G.- (8x) Washers
WARNING
1. The wall or mounting surface must be capable of supporting the combined weight of the
mount and the display; if not, the structure must be reinforced.
2. Locate pipes, wires, or any other hazards in the wall where you with to install the mount
before drilling.
3. Safety gear and proper tools must be used. Failure to do so can result in injury or damage.
4. Two people are recommended for installation. do not attempt to lift a heavy display without
assistance.
5. Follow all instructions and recommendations regarding adequate ventilation and suitable
locations for mounting your display.
INSTALLATION
1. Use the wall bracket as a template to make two holes in the wall with a depth of Ø10 mm
and 50 mm. Insert 4 plastic anchors into the holes.
2. Place the bracket on the wall and screw 4 self-screws into the plastic anchors to fix the
bracket to the wall.
3. Install the TV on the fixed base using the quick thread screws, found in the bag of parts
supplied
4. Loosen the nut to adjust the angle of the TV between -15º and + 15º degrees until you get
the right position. Then firmly secure the fixing screws.