Davin DV-101D Manual De Instrucciones página 6

1.0 GENERAL
The DV-101D is a multifunctional digital seconds
time clock.
1.1 TECHNISCHE GEGEVENS
Dimensions
Required voltage
Max. Output
Isolation level
1.2 INSTALLATION OF THE DV-101D
The DV-101D must be connected to the mains
voltage via a grounded socket near the water
barrel.
Remove the front panel of the DV-101D
housing.
At the bottom of the housing you will find 2
fixing holes through which a screw can be put.
You can mount the housing onto a (flat) surface
with the 2 screws.
The DV-101D has a 6 Amp (thermal) fuse.
This fuse turns off the DV-101D automatically
in case of an overload and / or short-circuits
(see 1.8).
1.3 CONNECTING A PUMP TO THE DV-101D
You can connect a random pump to the
DV-101D.
However, in this case the nominal power of the
pump should not be higher than 5 Amp.
1.4 SETTING THE DV-101D
In this manual we will limit ourselves to discuss
the general functions of the time clock.
Special functions of the time clock can be found
in the (supplied) factory manual.
8
DV-101D Binnenwerk PMS.indd 6
Manual DV‑101D
: 210 x 115 x 110mm.
: 230 Vac / 50Hz.
: 6 Amperes.
: IP-44
1.5 SETTING THE TIME CLOCK
Setting the time
• The date and time are set in the factory.
Setting the language
1. Press the menu button 1x
2. Using the arrow key, select LANGUAGE
3. Now press the OK button
4. Using the arrow key, select English
5. Now press the OK button
6. The language configuration is now
complete.
1.6 PROGRAMMING THE CHANGEOVER
TIMES
The DV-101D time clock can be used as a
seconds timer (see 1.6.1), or as a minute timer
(see 1.6.2).
1.6.1 PROGRAMMING THE CHANGEOVER
TIMES IN SECONDS (IMPULSE)
The DV-101D now functions as a seconds timer.
At the moment of switching 1 pulse is given; the
duration of this pulse can be programmed from
1 to 99 seconds.
You only have to program the start time in the
DV-101D.
Inputting a new programme (impulse)
1. Press the menu button 1x
2. Using the arrow key, select PROGRAM
3. Now press the OK button
4. Using the arrow key, select NEW
5. Now press the OK button
6. Using the two buttons on the left, select
VACATION / WEEKLY
7. Now press the OK button
8. Using the two buttons on the left, select
impulse
28-3-2012 2:18:45