• When the battery is fully charged, slide it out from the AC charger and slide it in the
power tool so that it locks in place.
Charging indicators
The AC charger has charging indicators which indicate the status of the charging process:
LED
Red
Green
• It takes about 1,5 hour to fully charge the power tool.
• AC charger and battery may heat up during charging. It is a normal behavior.
• When power tool is not in use, it is recommended to charge the battery every three months.
• When you notice that the power tool performance is decreasing, recharge the battery.
Fitting and removing hose
To fit the hose follow the below instructions:
• Loosen the tightening nut (5) by turning it clockwise.
• Slide the thread of the hose into the chuck (4) until the stop.
• Tighten the nut (5) by turning it anticlockwise.
To remove the hose, loosen the tightening nut by turning it clockwise. Grasp and pull the hose so
that it detaches from the chuck. Store the hose in the storage area on the top of the power tool.
Fitting and removing the adapters
There are 3 adapters included in the set:
• Bicycle tire adapter
• Sport ball needle
• Universal adapter intended for pumping up air beds or inflatable swimming pools
The hose is tipped with a clip-on tire valve which can be directly clipped on the valve stem
of car/bicycle tire.
To fit the adapter properly follow the below instructions:
• Insert required adapter into the clip-on tire. valve and then lock it.
• After operation, unlock the valve, remove the adapter and put it inside the accessory
compartment in the base of the power tool.
Work light
There is a work light (6) above the ON/OFF switch. It turns on when the ON/OFF switch is
pressed. It turns off when the ON/OFF switch is released.
Warning: The work light is intended to illuminate the power tool's direct area of working
operation and is not suitable for other purposes. Do not look directly into the light. Risk
of eye damage!
EN
Battery charging in progress
Battery charging finished, battery fully charged
36
Status