Lorell 69387 Manual De Instrucciones

Assembly Instructions
Cam Locks Klix Cam
7 Pcs 7 Pcs
5 Pcs + 2 extra Pcs
+ 2 extra Pcs + 2 extra Pcs
STEP 1
These instructions detail if the return
is to be positioned on the right side if
you are sitting at the desk. If you wish
for the return to be positioned on the
left, you will need to reverse the
position of the items accordingly
STEP 3
COMPLETED ASSEMBLY
IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts
from being scratched.
• Check to make sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packaging straps before your start to assemble.
• Do not tighten all screws/bolts until pieces are completely assembled.
• Keep all hardware parts out of children's reach.
• It is recommended for 2 persons to complete this assembly.
69387/69421/69979, 69388/69422/69980, 69389/69423/34400
Dowel
Repeat 4 X
Insert three additional cam
locks and cams in the
additional positions
provided. (Two in the
underside of the
worksurface and back
panel and one additional in
the side and back panels)
69554/69555/18215/18216/69594/18263
Screw #4 x / "
5
8
12 Pcs + 2 extra Pcs
STEP 2
Insert the four adjustable
glides in the back panel
and side leg panel as shown
Insert 4 each screws in the
two L-Brackets as shown
It is easier to install two of the flat
brackets to the assembled desk
unit first rather than the return
unit. This allows for easier
installation of the return unit. After
securing the return unit to the
desk unit top, install the additional
third flat back to the back panel of
the return unit and desk leg.
Secure all brackets with four
screws in each.
Once the return unit has been properly
installed, cover all exposed Klix Cams
with the Stickers provided.
Reversible Return Shell
Cam Cover
I-Bracket Screw M6 x 16mm
7 Pcs
2 Pcs 12 Pcs
+ 2 extra Pcs
IMPORTANT:
If attaching pedestal(s)
LLR69398/69432/69987
/69562,remove L brackets
from leg panel.
K
Cam Covers
5 Pcs