Descargar Imprimir esta página

Lorell Fortress 60930 Instrucciones Para Ensamble

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Desk Assembly Instructions
Figure 3
Leg Slot
Leg Bracket
1-800-383-7414
Figure 1
Figure 2
#8 x 1/2" screws
Figure 5
Read all instructions and review illustrations before assembly.
WARNING
This desk is heavy. Two or more people are required
for assembly. Attempting to assemble this desk
alone may cause injury. Take care when handling
metal parts. Sharp edges may cause injury.
Tools needed for assembly:
Phillips Screwdriver
Level
1.
Lock drawers. Then, with two or more people,
turn the desk upside down. Place on cardboard or
carpeted surface in order to prevent the top from being
scratched.
2.
Insert a leg bracket into the leg slot as shown in
Figures 1 & 3. Note: the bracket may need to flip up
or down depending on which corner the leg is being
installed.
3.
Insert the open end of the leg into the socket as shown
in Figures 2 & 4.
4.
Align holes in the leg bracket with the holes in the
pedestal and install 2 #8 x 1/2" screws for each leg.
Note: See Figure 5 for hole alignment on front corners
with drawers.
5.
Repeat for remaining legs.
6.
Use two or more people to turn the desk upright.
7.
Place in desired location and adjust leveling glides as
needed to level desk front to back and side to side.
Figure 4
20085

Publicidad

loading

Resumen de contenidos para Lorell Fortress 60930

  • Página 1 Desk Assembly Instructions Read all instructions and review illustrations before assembly. Figure 1 WARNING This desk is heavy. Two or more people are required for assembly. Attempting to assemble this desk alone may cause injury. Take care when handling metal parts. Sharp edges may cause injury. Tools needed for assembly: Phillips Screwdriver Level...
  • Página 2 Return Desk Assembly Instructions With two or more people, turn the return desk upside down. Place on cardboard or carpeted surface in order to prevent the top from being scratched. Follow instructions 2-5 on previous page for leg installation. Remove the top connector plate and filler block. See Figure 6.
  • Página 3 Instructions de Montage du Bureau Lisez toutes les instructions et passez en revue les illustrations avant le montage. Figure 1 AVERTISSEMENT Ce bureau est lourd. Il faut au moins deux personnes pour en faire le montage. Si vous tentez d’assembler ce bureau seul, vous risquez de vous blesser.
  • Página 4 Instructions de Montage du Bureau-Retour Avec l’aide d’au moins une autre personne, retournez le bureau-retour à l’envers. Placez-le sur un carton ou sur une moquette afin de ne pas égratigner la surface. Suivez les instructions 2 à 5 sur la page précédente pour l’installation des pieds.
  • Página 5: Instrucciones Para Ensamble De Escritorio

    Instrucciones para ensamble de Escritorio Lea todas las instrucciones y revise las ilustraciones antes de ensamblar. Figura 1 PRECAUCION Este escritorio es pesado, se requiere de dos o más personas para ensamblarlo. Hay riesgo de lesión si se intenta ensamblar sin ayuda. Favor de extremar cuidados cuando se manejen partes metálicas.
  • Página 6: Instrucciones Para Ensamble De Retorno

    Instrucciones para ensamble de Retorno Entre dos personas gire el escritorio boca abajo, coloque sobre cartón o alfombra para evitar ralladuras. Siga los pasos 2-5 de la página anterior para la instalación de las patas. Remueva la placa de ensamble de la mesa y el bloque de relleno, vea la Figura 6.

Este manual también es adecuado para:

Fortress 66949Fortress 60926Fortress 66908Fortress 66905