Installing The At-Mcr12 Chassis - Allied Telesyn AT-MCR12 Manual De Instalación

The AT-MCR12 Rackmount Chassis
I I I I n n n n s s s s t t t t a a a a l l l l l l l l i i i i n n n n g g g g t t t t h h h h e e e e A A A A T T T T - - - - M M M M C C C C R R R R 1 1 1 1 2 2 2 2 C C C C h h h h a a a a s s s s s s s s i i i i s s s s
The following pages provide the procedures to install:
Media converters in the chassis
The chassis in the rack
The chassis on a desktop
To install individual media converters in the chassis
1. Remove the single screw that secures the mounting guide in the AT-MCR12 chassis slot
where you are installing the media converter. Remove the mounting guide by sliding it
out. Keep the mounting guides in the slots where you are not installing media
converters at this time.
2. Align the mounting guide on the media converter as shown in Figure 2. Orient the
media converter on its side with the top cover on the left and the base plate on the
right. The top tab on the mounting guide, indicated Tab A on Figure 2, slides loosely
into the frontmost vent on the side of the media converter.
F F F F i i i i g g g g u u u u r r r r e e e e 2 2 2 2 : : : : Installing the Mounting Guide on the Media Converter
6
Tab A