Hayward SKIM-VAC SP1104 Serie El Manual Del Propietario página 2

INSTRUCTIONS
1. Place vacuum cleaner head on vacuum hose and
prepare for vacuuming as usual. With pump and filter
system operating, fil vacuum hose with water.
2. Keeping water in hose, place hose end over SKIM-VAC
hose connection.
3. Insert SKIM-VAC into skimmer and fimily place over
basket. Hold SKIM-VAC in place until all air is
evacuated from vacuum hose. Once the air is removed,
the pump suction will hold the SKIM-VAC firmly in
place.
4. To remove SKIM-VAC, merely grasp the hose
connection (near the plate) and give a sideward twist
or briefly lift vacuum head from pool. This will "break"
the suction and allow easy removal.
NOTE:
Take care not to damage or scuff-up SKIM-VAC's
specially designed sealing surface. For best results,
store the SKIM-VAC in a safe place when not in use.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS