Program Mode - Kingfisher INTERNATIONAL KI7010B Guía De Referencia Rápida

QUICK REFERENCE GUIDE: KI7010B SERIES AUTOMATED VARIABLE OPTICAL ATTENUATOR
• To install a connector adaptor, align the locating slot on the side of the
adaptor with that on the instrument connector, and press it on.
•
To remove an adaptor, press the release button on the back of the
instrument and then pull off the adaptor. It may be easier with a test lead in
place.
•
To turn on the instrument for permanent operation, press [POWER] for 3
seconds until 'Perm' is displayed at the top of the LCD.
•
To select calibration wavelength, press [λ] [-/+] [SET].
•
To set attenuation level, press [-/+].
•
Low battery is indicated with a battery symbol.
STEP MODE
•
To operate in the step mode, simply press the [STEP] button. Pressing the
[-/+] button will now increment attenuation according to the previously set
step size.
•
To view the current step size, press [SET STEP].
To adjust the step size, press [SET STEP] [-/+] [SET]. The unit will now
operate in step mode using the new step value.
ABSOLUTE / RELATIVE DISPLAY MODE
•
To enter Absolute/Relative display mode, set the attenuation level as
required and press [ABS/REL].
•
To zero the display, press [REL].
• To set the display to an arbitrary value, adjust the attenuation with the [-/+]
button, then press [SET].
•
To exit this mode, press [ABS/REL] or [MENU].

PROGRAM MODE

•
To use a previously set up program, press [PROGRAM] [-/+] [SET] and [GO].
•
To halt the program, press [STOP]. Press [GO] to continue.
•
Press [RESTART] to restart the program.
•
To exit this mode, press [STOP] then [MENU].
English
1