Kingfisher INTERNATIONAL KI9800A Serie Guía De Referencia Rápida página 3

Quick Reference Guide – KI 9800 Optical Light Source

Press and hold [LEVEL], then press [] for 3 seconds
to set output power to factory default. Alternatively, press
[POWER].

AutoTest:

To start AutoTest, press [POWER] then press [AUTO]. To
end, press [AUTO] again or turn the instrument off.

TamperLock Mode:

While in TamperLock Mode, user is prevented from
changing wavelength and laser output power.

Press [POWER], turn the emitter on, then press and hold
[] while pressing [LEVEL] for 5 seconds. Display will
show "codE'.

Enter 6 key sequence using any keys except [POWER].
Triple beep and "LOut" on display will indicate completion.

While TamperLock is active, "<<<" and ">>>" symbols will
be displayed.
Revision 2 3Sep2013
Page 2 / 14

To cancel your entry, press [POWER].

To clear TamperLock Mode, press [POWER] while
holding down [] and [LEVEL]. When display show
"codE", enter six key sequence.

If the correct sequence had been entered, "PASS" will be
displayed indicating that TamperLock had been cleared.

In case where entered sequence was not correct, "FAIL x"
will be displayed (where x is attempt count).

TamperLock will be cleared after three unsuccessful
attempts.