This package includes (Style of push button and chime
may vary from illustration):
• Wireless Christmas bell chime
• Wireless push button with battery
• Hardware pack
This chime requires 3 "AA" alkaline batteries (not
included). In typical use, alkaline batteries will last up
to 6 months.
Figure 1
Jumpers
Figure 2
Figure 3
© 2008 HeathCo LLC
INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
Keyhole
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screwdriver
(see Figure 1). See diagram inside push button for
correct battery orientation. Note: If batteries are
preinstalled, remove orange battery tab.
2. Open chime battery compartment. Press in
latch on rear of chime and lift off battery cover
(see Figure 2).
3. Install 3 alkaline "AA" batteries. Make sure
batteries are oriented properly (see Figure 3).
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push but-
ton work properly. If chime does not sound, see
Troubleshooting.
Wireless Christmas
WARNING: To prevent possible SERIOUS
Chime
598-1127-03