Health O Meter 598-1127-03 Manual De Instrucciones página 5

3. To change the code, either:
• Add a jumper to the same location on both the push button and the chime
or...
• Remove a jumper from the same location on both the push button and the
chime or...
• Move a jumper on the push button from one location to another. Move the
corresponding jumper on the chime to match the new location in the push
button.
Example: Move jumper at location "1" to location "2" on both the push
button and the chime.
Note: Code positions 1 through 3 must be exactly the same for both the
push button and chime for this system to function.
Note: Unit will come factory set with jumpers in locations 1, 2, and 3 on the
push button and on the chime (see Figure 7).
The range of the wireless chime can vary with location, temperature, and
battery condition.
Inside Chime
598-1127-03
* Code Settings 1-3
Must Match Both Push
Button and Chime
Note: Some models might require the use
of tweezers to remove and replace the
jumpers.
Figure 7
-5-
Inside Push
Button