Westinghouse WST5019ME Serie Manual De Instrucciones página 7

Using as a Steam Iron
The Temperature Control Dial must remain at the "MAX" setting
while steam ironing.
1. Turn the Temperature Control Dial to the "MIN" setting and
make sure that the Steam Button is in the NO STEAM
position.
2. Make sure that the Iron is unplugged and has cooled com-
pletely before filling.
CAUTION: IF THE IRON IS HOT, DO NOT FILL WITH
WATER.
3. Filling the Water Tank: Place the Iron in the horizontal
position (on its Soleplate). Using the Filler Cup provided,
slowly pour water through the Water Fill Opening until the
Water Tank is filled to the Maximum Water Level Line; DO
NOT OVERFILL.
IMPORTANT: Use tap water or distilled water only. Do
not use chemically descaled water or any other liquids.
4. With the Water Tank full, stand the Iron in the vertical posi-
tion (on its Heel Rest) on a heat resistant surface and plug
into a 127V outlet.
5. Turn the Temperature Control Dial to the "MAX" setting. The
red Thermostat Light will illuminate, indicating that the Iron
is heating.
NOTE: For best results, check garment labels for the tem-
perature and steam settings recommended by the fabric
manufacturer.
6. Once the Iron has reached the set temperature, the red
Thermostat Light will go off, indicating that the Iron is ready
for use.
NOTE: The red Thermostat Light will continue to cycle off
and on during use as the Iron maintains the desired temper-
ature.
7. Press the Steam Button into the STEAM position. Steam will
be released continuously once the Iron is held in the hori-
zontal position.
6