Moulinex Duo cups Manual Del Usuario página 15

2. Insert the plug into the socket.
3. Lift up the cover, fill the tank
with cold water but do not
exceed the MAX level mark inside
the tank.
4. Close the cover.
5. Position the cups below the 2
points of coffee spouts.
6. Start the brewing process by
pressing the ON button.
PREPARING THE COFFEE
(Follow figures 1 to 5)
1. Lift up the cover and fill the
tank with water: MIN in the
water tank is to prepare 1 cup of
coffee. MAX is to prepare 2 cups
of coffee.
2. Ensure the water level does
not exceed the MAX level mark
inside the tank.
3. Remove the filter holder and the
permanent filter.
4. Put ground coffee into the
permanent filter: the level MIN
is to prepare 1 cup of coffee.
The level MAX is to prepare 2
cups of coffee.
WARNING: Use only ground
coffee (pods are not compatible)
and never exceed the MAX level
in the permanent filter.
5. For 1 cup of coffee: Ensure
that the cup is placed properly
in its position: below the 2
points of coffee spout.
For 2 cups of coffee: Ensure that
the 2 cups are place properly in
their position: 1 cup below each
point of coffee spout.
6. Press the ON button and
the pilot lamp illuminates, to
indicate the unit is on.
7. Switch off the appliance if you
want to stop the brewing.
Your appliance will turn off
automatically after the end of
the coffee cycle (when there
is no more water in the water
tank).
Wait for 1 minute after the
button is off (water must flow
from the end of the filter holder)
then take off your cup(s).
INGENIOUSNESS: For breakfast,
you can position a bowl instead of
2 cups!
IMPORTANT
• Use on a flat surface so that the
distribution of coffee is done
properly in 2 cups.
• There is no drip stop: before
enjoying your coffee, wait a few
minutes after the end of the
cycle so that the water in the
filter holder is well past.
• It is normal to have a small
difference in the volume of
coffee in the 2 cups.
• It is normal to have some coffee
EN
11