BaByliss PRO Orchid BAB2669ORCE Manual Del Usuario página 4

ENGLISH
Conical wand
BAB2669ORCE
The BaBylissPRO™ BAB2669ORCE conical
curling iron lets you express your creativity.
First, make sure you protect your fingers by
wearing the protective gloves that come
with the conical curling iron.
To create pretty, bouncy, soft curls that are
tighter at the bottom, take up a section of
hair with your thumb and index finger, hol-
ding the ends at the stay-cool tip.
Then wind the section of hair up along the
heating barrel.
Stop before the widest part of the barrel
gets too close to the scalp.
Hold the section tightly in this position for
5 to 6 seconds.
Release the ends of your the hair and allow
the iron to slide from the section, naturally
and without pulling.
For a soft, bouncy curl that opens at the
bottom, grip the ends of the section of hair
at the widest end of the heating barrel and
wind the section down along the barrel un-
til you reach the thinnest part of the barrel
near the stay-cool tip.
Hold the section in place for 5 to 6 seconds.
Release the ends of your the hair and allow
the iron to slide from the section, naturally
and without pulling.
Allow your the hair to cool before handling.
Heat setting
1-5
5-10
10-15
15-20
20-25
25-30
TEMPERATURE CONTROL GUIDE
Hair type
synthetic, damaged
coloured
thin
medium
thick
wavy, afro
FEATURES
• Titanium Technology conical barrel
32-19mm
• 30-setting temperature control
• On/Off switch
• Indicator light
• Automatic shut-off after 72 min
• Stay-cool tip
• Swivel cord
• Finger heat shields
• 49W
Titanium coating
Incomparable durability. Heat distribution
with perfect uniformity and perfect heat
stability for optimum results.
Temperature control
The temperature selector lets you set the
exact temperature desired (30 settings).
For fine hair, use a lower temperature to
get the best results and to respect the
hair's integrity perfectly.
For thick, wavy or hard to curl hair, use a
higher temperature for best results.
INSTRUCTIONS FOR USE
• Plug the unit in and press on the 'I' but-
ton. The iron will begin to heat up. Set
the temperature using the selector. The
red indicator light will flash for a while
until the unit reaches the desired tem-
perature. When the light is fixed, the unit
is ready to use.
Temperature °C
135°C - 140°C
140°C - 145°C
145°C - 155°C
155°C - 165°C
165°C - 185°C
185°C - 200°C
4