Fax +32 2 359 95 50
Filling and cleaning the tank
Open the tank cap (7), remove the small filter (8) (Figure 1 A), fill the tank with clean water by
slightly tilting the appliance (head down) (Figure 2 B) to facilitate the exit of air. The appliance
must be disconnected from the charger during all operations. Then replace the clean filter and
cap.
After each use, empty and rinse the tank (6), never forget to wash the small filter (8) and put it
back.
Never place the appliance under the tap to fill the tank without first unplugging the charger
(Figure 3 C).
Effectiveness
With its EMERY wipe (5) this appliance does not need detergent but in case of heavy dirt or in
heavily polluted environments, diluted cleaning products may be added or even just a few
drops of vinegar or alcohol, to help degreasing and not to clog your windows. This solution is
more convenient, ecological and economic.
You clean your window twice less often because they will be perfectly defatted and thus
become dirty again more slowly.
Attention! If the quantity of detergent used is too high or if the detergent is not sufficiently
diluted, this can damage the joints of the appliance and cause leaks.
Dilute the detergent in a way that it does not constitute more than 10% of the solution.
Attention! No liability shall be accepted for defects which result from the fact that this
instruction has not been respected.
Normally finishing with microfiber wipe (9) is sufficient, and it depends on outside pollution
and/or inner and outer elements that dirty your glass surfaces, such as urban traffic, flies,
children, pets etc.
The main property of this type of microfiber wipe (9) is to retain not only dust, but also and
especially fats.
In all cases on sensitive surfaces it is better to test your wipe on a hidden area so as not to
damage the appearance.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
15
Assembly page 15/76
TKG WSP 1000 - 130604