Kalorik TKG WSP 1000 Manual Del Usuario página 18

Fax +32 2 359 95 50
•
Put the used or leaking accumulator in a bag and bring it to a recycling park. For more
information, contact your town authorities.
Technical problems and solutions
Problems encountered
The device suddenly
stops or does not start
No liquid spray
Marks are left on
cleaned surface
All these solutions are basic elements to perform before any requests for technical assistance.
For all other possible problems, contact your dealer or the manufacturer.
Specifications (subject to technical modifications)
Nominal power of the appliance
Nominal LITHIUM battery voltage
Nominal battery capacity
Nominal charger voltage
Nominal charger capacity
Duration of use in full charge
Maximum charging time
Tank volume
Noise level
Product weight
Working width
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
The user manual is by simple request also available in electronic format from the after-sales
service (see warranty card).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Possible identifications
Battery charge is too low
Needs more cleaning water
Exit hole is blocked
Scraping joint is dirty
Wipe is dirty
Scraping joint is damaged
There is too many detergent
Water is dirty
18
Assembly page 18/76
Proposed solutions
Recharge the battery
Fill the tank
Unclog the exit
Clean the flexible seal
Replace clean wipe
Replace the scraping joint
(Service assistance)
Reduce the dosage
Change water in tank
8 Watts
3.7 Volts
2000 mAh
5 Volts
900 mAh
20-25 minutes
2 hours
130 ml
62 dB(A)
0.7 kg
28 cm
on the
TKG WSP 1000 - 130604