August WP200 Manual De Instrucciones página 5

4.Switch on the WP200, the software will be enabled
automatically and can be found in the system tray icons.
5.Click on the software icon to see the application's page
and settings.
■ Spotlight Settings
- Adjust the slide bar to increase or decrease the background
brightness in spotlight mode.
■ Digital Laser Settings
- Adjust the colour bar to change the colour of the digital
laser.
■ Pointer Speed Settings
- Adjust the slide bar to increase or decrease the speed of
pointer.
■ Auto Startup
- Enables the auto run of the software as soon as the USB is
plugged in in order to access all features (basic and
advanced).
■ Lost Dongle Notification/Feature
- Enables an audio prompt to be announced through the
computer's speakers after 22 seconds when the device is
switched off to remind you to unplug the USB receiver and
not forget it.
■ Alarm Timer
- Enables a vibrating timer on the device. Input the required
time in minutes. Press the Tab button on the WP200 to
display the remaining time. The Device will vibrate once the
time has elapsed.
- 5 -
6. Charging
This device contains a built-in Lithium rechargeable battery.
When then battery is low, the LED display will show
To charge the device, connect the WP200 to a powered USB
port by using the provided USB power cable.
While charging, the Status LED will light red. Once fully
charged, the status LED will go off.
A full charge will take approximatively 1 hour.
.
- 6 -