Moen PureTouch Classic 7025 Serie Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MICROTECH
1. Install a new filter by wetting the outlet ports with
water and then inserting into the round filter ports
on the faucet head and pushing the filter and head
together. Both outlet ports must be
fully inserted into the filter ports.
2. Install the filter and faucet head
assembly on to the spout by wetting the
faucet head o-ring seal and rubber spacer and
then carefully sliding the free end of the filter
into the spout. The head will need to be initially
turned approximately 1/2 turn counter clockwise from
its normal position to slip past the safety catch. Lock the
head into place by simultaneously pushing and twisting the
head clockwise. When properly installed the head will feel
secure, and will be correctly oriented on the spout.
3. Reset the filter life indicator by pushing the filter
button 3 times. Wait 10 seconds. You should not be
running water while resetting the filter life indicator
because the filter button will remain depressed with the
first push as it switches to filter mode. The filter life indicator
has been correctly reset if a short series of rapidly flashing green
light occurs, indicating that the new filter flushing
period has begun.
4. Flush the filter (see page 3) for 5 minutes before
initial use.
Your new Moen faucet is now ready for normal use.
To replace or install filter -
1. Turn off the faucet. Remove the faucet head by
twisting it approximately 1/4 turn counter clockwise to
unlock it. Gently pull the faucet head away from the
spout and twist it approximately another 1/4 turn to get
the faucet head past the safety catch. The faucet head and
depleted filter (if one is installed) can now be pulled
completely out of the spout.
2. The filter is held to the faucet head by two outlet
ports, which connect into the head. Remove the old
filter by simply pulling it straight off. Discard the old filter
and install a new MicroTech 400 or 600 filter.
Note: The faucet will function correctly in unfiltered stream mode
with or without a filter installed. The faucet will not function correctly in
filter mode without a filter. If a filter is not installed and the filter button is
depressed, unfiltered water will flow from both the filtered water outlet and the
stream outlet aerator, and the filter button will not automatically stay depressed.
Use only Microtech 400 or 600 filter cartridges with the PureTouch
Filtering Faucet system. The Microtech filters are high performance carbon block
filters developed specifically for the PureTouch system.
INS215A
FILTER INSTALLATION/REPLACEMENT
HELPLINE: 1-877-DRINK-H2O
1-877-(374-6542)
Filtering Appliance
Faucet head o-ring seal
Spacer
Outlet Ports
Filter
Classi
c
8

Publicidad

Tabla de contenido
loading

Tabla de contenido