Avermedia AVerTV Nova T2 Guía Rápida página 4

Antenna Installation - When installing an outside antenna system, extreme care should be taken to prevent it from
touching such power lines or circuits, as contact with them may be fatal.
Outdoor Antenna Grounding - If an outside antenna is connected to the product, ensure that the antenna system is
grounded so as to provide some protection against voltage surges and built up static charges. Article 810.21 of the
National Electric Code, ANSI/NFPA No.70, provides information with regard to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to the antenna discharge unit, size of grounding conductors, location of
antenna-discharge unit, connection of grounding electrodes, and requirements for the grounding electrode.
(for CATV system installer) This reminder is provided to call the CATV systems installer's attention to Section 820.93 of the
National Electric Code, ANSI/NFPA 70:2005 (for US/Canada) and/or EN60728-11:2005 standard (for Europe), which
provide guidelines for proper grounding and, in particular, specify that the coaxial cable shield shall be connected to the
grounding system of the building, as close to the point of cable entry as practical.
The mark of crossed-out wheeled bin indicates that this product must not be disposed of with your other household waste.
Instead, you need to dispose of the waste equipment by handing it over to a designated collection point for the recycling of
waste electrical and electronic equipment. For more information about where to drop off your waste equipment for
recycling, please contact your household waste disposal service or the shop where you purchased the product.
№ РОСС TW. AГ98.B06472
Срок действия с
14.02.2013
Москва
AГ98
Disclaimer
All the screen shots in this documentation are only example images. The images may vary depending on the product and software
version. Information presented in this documentation has been carefully checked for reliability; however, no responsibility is assumed for
inaccuracies. The information contained in this documentation is subject to change without notice.
Copyright
©2014 by AVerMedia Technologies, Inc. All rights reserved.No part of this document may be reproduced or transmitted in
any form, or by any means (Electronic, mechanical, photocopy, recording, or otherwise) without prior written permission of
AVerMedia Technologies, Inc. Information in this document is subject to change without notice. AVerMedia Technologies,
Inc. reserves the right to modify, change, improve or enhance its products and to make changes in the content without
obligation to notify any person or organization of such changes. Please visit avermedia.com to get the updates of the
operation and use of AverMedia products. "AVerMedia" is a trademark (or registered trademark) of AVerMedia
Technologies, Inc. Other trademarks used herein for description purpose only belong to each of their companies. Made in
Taiwan (Expect Accessories). Picture shown may vary from actual product.
по 13.02.2015
г г