Rosewill RMS-TDM02 Guia De Instalacion página 7

Step 4 :
Insert C-A clip into the curved notch
Step 5 :
Install C-C sleeve into the hole of the arm connection set.
Step 6 :
Set the arm connection set
screw.
Step 7 :
Insert C-D block into the desk clamp base shaft and fasten the block in the suitable position with
C-E screw.
When assembling the arm connection set,
RMS-TDM02 Desk Mount Installation Guide
3
into the desk clamp base
3
C-D C-E
2
make its curve toward the front.
of the arm connection set.
3
, shaft and tighten the arm set with C-B
2
C-A
C-C
The gap should be on the
opposite side to C-A clip.
5
(Note the sleeve gap location)
3
C-B
B-B