Troubleshooting; Inflator - Wagan Tech iOnBoost V8 Air Manual De Usuario

TROUBLESHOOTING

Code Cause
F1 Internal Failure
F2 Internal Failure
F3 Temperature to low to
charge
F4 Internal Failure

INFLATOR

1. Connect the valve connector to the valve stem of the tire.
2. Press and hold the Power Button for 3 seconds.
3. Press the Air Pressure Unit Button to toggle between Bar, KG/cm2 and PSI.
4. If desired, set the pre-set tire pressure function with the "+" and "-" Air Pressure Setup
Buttons.
5. Press the Inflator button to start air flow.
6. If not using the pre-set tire pressure function, press the Inflator Button a second time to turn
the inflator off once the desired pressure is reached.
7. If using the pre-set tire pressure function, the inflator will stop automatically once the set
pressure is reached.
8. Remove valve connector from valve stem.
… Allow the unit to cool for 15 minutes after each 10 minutes of use.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
Air Pressure
units
Air Pressure
Target setting
©2021 Wagan Corporation. All Rights Reserved.
Solution
Do not use
Do not use
Charge unit in warmer place
Check that adapter is >5V 1A. If not, use a
different charge adapter. If the adapter is
already >5V 1A, do not use.
Current
Air pressure
7